Tektronix P52XXA Series P5200A Oscilloscope Probe, Differential Type, 50 MHz, Hook Tip, Alligator Clip, Pincer Clip

Note:

TMDP and THDP Series probes have the TekVPI® interface which enables smart communication between oscilloscope and probe - each TekVPI probe features controls and indicators located on the probe compensation box, designed to provide quick and easy access to the probe's most commonly required set-up controls and operating status. P52xxA Series probes have the Tektronix TekProbe® interface which communicates scale information to the oscilloscope.

The P5200A can be used with any oscilloscope and enables users to safely make measurements of floating circuits with their oscilloscope grounded.

Supplied with

2 hook clips

2 pincer clips

2 alligator clips

2 extension cables

Warning

Do not use the P5200A with scopes that have floating inputs (isolated inputs), such as the Tektronix TPS2000 Series. The P5200A requires an oscilloscope or other measurement instruments with grounded inputs.

Attenuation ratio is 1:50 and 1:500

Input impedance is 5Mohmll4pF

Maximum common mode voltage is ±1.3KV

Maximum Input voltage is 1000V CAT II

Wide compensation range (7pF to 30pF)

CMRR (typical) is 100kHz: > -60dB 3.2MHz: > -30dB 100MHz: > -26dB

Overrange indicator

Safety certified

Switchable attenuation

Switchable bandwidth limit

Cable length 1.5m (THDP & TMDP), 1.8m (P52xxA)

Switching power supply design

Motor drive design

Electronic ballast design

CRT display design

Power converter design and service

Power device evaluation

BNC interface (P5200A probes)

TekVPI interface (TMDP and THDP Series probes)

TekProbe interface

UL 61010-031 listed

CAN/CSA-C22.2

IEC 61010-031

IP20 Rating

CAT II