Telemecanique Sensors XY2CE Rope Pull Switch 229 mm, 2 NO/2 NC

Bekijk alle Rope Pull Switches

Subtotaal (1 eenheid)*

€ 411,27

(excl. BTW)

€ 497,64

(incl. BTW)

Add to Basket
selecteer of typ hoeveelheid
Beperkte voorraad
  • Plus verzending 2 stuk(s) vanaf 27 april 2026
  • Plus verzending 2 stuk(s) vanaf 27 april 2026
  • Plus verzending 3 stuk(s) vanaf 04 juni 2026
Heeft u meer nodig? Klik op 'Controleer leverdata' voor extra voorraad en levertijden.
Aantal stuks
Per stuk
1 +€ 411,27

*prijsindicatie

RS-stocknr.:
130-0882
Fabrikantnummer:
XY2CE1A290
Fabrikant:
Telemecanique Sensors
Zoek vergelijkbare producten door een of meer kenmerken te selecteren.
Alles selecteren

Merk

Telemecanique Sensors

Product Type

Rope Pull Switch

Contact Configuration

2 NO/2 NC

IP Rating

IP66

Number of Cable Entries

3

Series

XY2CE

Contact AC Voltage

240V ac

Contact DC Voltage

250V dc

E-Stop Button

Yes

Reset Button

Yes

Minimum Operating Temperature

-25°C

Maximum Operating Temperature

70°C

Length

229mm

Housing Material

Stainless Steel

Standards/Approvals

UL (NISD), CSA C 22-2, EAC, CSA, CCC, EN/IEC 60947-5-5, UL 508

Width

105mm

Depth

142mm

Hazardous Area Certification

ATEX

Mechanical Life

60000Cycles

Conduit Entry

M20

Land van herkomst:
MA

Telemecanique XY2CE & XY2CB Emergency Stop Rope Pull Switches


These emergency stop trip wire switches are designed to reduce the risk of injury to persons and damage either to machines or work in progress. They can be tripped by a single human action when a normal emergency stop function is not available and will also trip in the event of the trip wire breaking.

Switches incorporate positive opening operation contacts, the tripping of the switch being made with positive action

The switch latches in the tripped position (N/C safety contact(s) open). The function of the N/O contact is purely for signalling

Incorporates a reset button, which re-closes the safety contact(s), restarting of the machine must only be achieved by manual operation of a control device within the machine start circuit, remote to the trip wire switch

Recommended distance between cable supports is 15m (for model XY2-CB30 a distance of 20m is recommended)

The XY2 CE1A296 comes with a pilot light (direct supply)

Note

The XY2 CB switch must not be used if the installation requires that the trip wire be angled but the XY2 CE switch can. In this case, the total sum of the angles through which the trip wire bends must not exceed 180°.

Standards

EN/ISO 13850:2006

Gerelateerde Links