Burkert Solenoid Valve 140898, 2 port , NC, 230 V ac, 1in

  • RS-stocknr. 370-0157
  • Fabrikantnummer 140898
  • Fabrikant Burkert
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

6211 Series 2//2 way Servo-Assisted, Normally Closed Solenoid Valves

Brass body with separating servo membrane and polyamide coil
Total or no control
For use with gas, air, water and oils, other liquids that do not contain oils or greases, hot water up to 70°C, alkaline and bleaching detergents
NBR seal material
Maximum viscosity 22 mm2/s
0.5 to 10 bar pressure range
Ambient temperature range 0 to +70°C
Power consumption 4W (DC Inrush); 9VA (AC Inrush); 4W (DC Hold); 6VA (AC Hold)

Note

Only use on mediums suitable for NBR seal material and brass.

//media.rs-online.com/t_line/L439060-04.gif
//media.rs-online.com/t_line/L439240-02.gif

Compact solenoid valves suitable for most gas and fluid handling applications. Where practical, valves are shown with a schematic diagram showing the (circuit) function. The diagram is laid out so that the left-hand side of the diagram describes the valves operation when the coil is energised. When the coil is de-energised, the spring (or servo-assist) return controls the valve and is described on the right-hand side of the diagram. The 3 / 2-way designation indicates a valve with three ports and two modes of operation. It is normal practice to refer to 2 / 2-way valves as two ways. The port designations A, B, P, P1, P2 and R are used on the schematic diagrams and are marked on the valve bodies. Valve bodies are marked for a specific circuit function but can often be used for other functions. Reference to the schematic diagrams and technical specifications indicates the appropriate connections and pressure capabilities when an alternative circuit function is required.

Specificaties
Kenmerk Waarde
Supply Voltage 230 V ac
Number of Ports 2
Operation Pilot
Connection 1 in G Female
Connection Size 1in
Default Valve Position NC
Suitable Applications Liquid, Neutral Gas
Type 2/2
Orifice Diameter 20mm
Body Material Brass
Maximum Working Pressure 10 bar
Operating Temperature Range 0 → +55 °C
Minimum Operating Temperature 0°C
Maximum Operating Temperature +55°C
Connection Gender Female
Maximum Opening Time 350ms
Thread Standard or Connection Type G
Flow Factor Kv 8.3m³/h
Servo Assist Yes
Series 6211
Maximum Closing Time 600ms
5 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
110,85
(excl. BTW)
134,13
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 110,85
Related Products
Solenoid valves with pivoted armatures. Lockable manual over-ride3-pin ...
Description:
Solenoid valves with pivoted armatures. Lockable manual over-ride3-pin DIN connector rated to IP65 can be positioned through 360° in 90° incrementsDuty cycle intermittent operation 40% 30 min8W nominal coil powerPower consumption 30VA (in-rush), 15 VA/8W (hold) a.c, A 8W d.c.Zero ...
Manifold type mounting valveMedium is only in contact ...
Description:
Manifold type mounting valveMedium is only in contact with the valve internals and bodyHigh quality seal material FPM (Viton) standardCoil can be changed easily with valve in placeCoil can be locked in 4 x 90° positions or move freely between, ...
Range of solenoid valves 3 // 2 NF ...
Description:
Range of solenoid valves 3 // 2 NF DL output, with exhaust when off, for neutral liquids up to +100 °C.Mounting on simple or multi-track bases.Able to change the solenoid without removing the valve.High quality FPM (Viton) sealing material as ...
Modular direct acting solenoid valve system. Brass body ...
Description:
Modular direct acting solenoid valve system. Brass body with polyamide coilCoil can be changed easily with valve in placeCoil can be locked in four by 90° positions or move free between, as requiredFPM high quality seal material Suitable for compressed ...