TE Connectivity, DuraSeal Butt Splice Connector, Red, Insulated, Tin 10 AWG
- RS-stocknr.:
- 136-1900
- Fabrikantnummer:
- 967398-000
- Fabrikant:
- TE Connectivity
Subtotaal (1 doos van 1000 eenheden)*
€ 628,96
(excl. BTW)
€ 761,04
(incl. BTW)
GRATIS bezorging voor bestellingen van meer dan € 90,00
Tijdelijk niet op voorraad
- Verzending 1 stuk(s) vanaf 10 juni 2026
- Plus verzending 45 stuk(s) vanaf 17 juni 2026
- Plus verzending 9 stuk(s) vanaf 18 juni 2026
Heeft u meer nodig? Klik op 'Controleer leverdata' voor extra voorraad en levertijden.
Dozen | Per Doos | Per stuk* |
|---|---|---|
| 1 + | € 628,96 | € 0,629 |
*prijsindicatie
- RS-stocknr.:
- 136-1900
- Fabrikantnummer:
- 967398-000
- Fabrikant:
- TE Connectivity
Specificaties
Datasheets
Wetgeving en compliance
Productomschrijving
Zoek vergelijkbare producten door een of meer kenmerken te selecteren.
Alles selecteren | Attribuut | Waarde |
|---|---|---|
| Merk | TE Connectivity | |
| Product Type | Splice Connector | |
| Splice Type | Butt | |
| Minimum Wire Size AWG | 26AWG | |
| Diameter | 3.7mm | |
| Insulation | Insulated | |
| Maximum Wire Size AWG | 10AWG | |
| Colour | Red | |
| Insulation Material | Nylon | |
| Series | DuraSeal | |
| Contact Material | Copper | |
| Contact Plating | Tin | |
| Termination Type | Crimp | |
| Standards/Approvals | No | |
| Alles selecteren | ||
|---|---|---|
Merk TE Connectivity | ||
Product Type Splice Connector | ||
Splice Type Butt | ||
Minimum Wire Size AWG 26AWG | ||
Diameter 3.7mm | ||
Insulation Insulated | ||
Maximum Wire Size AWG 10AWG | ||
Colour Red | ||
Insulation Material Nylon | ||
Series DuraSeal | ||
Contact Material Copper | ||
Contact Plating Tin | ||
Termination Type Crimp | ||
Standards/Approvals No | ||
- Land van herkomst:
- MX
Splices
Red 0.25 - 1.6 mm²
Blue 1.0 - 2.6 mm²
Yellow 2.7 - 6.6 mm²
Duraseal Heatshrinkable
TE heat shrinkable pre-insulated nylon splices and crimp terminals provide reliable connections, especially where environmental sealing is important. Covering cable sizes from 0.5mm - 6.0mm², they are designed for use where water or condensation may be encountered, or where abrasion or mechanical abuse could be problematic. To complete a joint, the cable connector is crimped in the traditional manner, and the sleeving is then heated to shrink around the cable insulation. Special adhesive flows during the heating to seal the joint.
• The TE Duraseal kit is especially suited for use in automotive (approved by most car manufacturers) and marine builds, where environmental sealing is important
• Kits are also available comprising various heat-shrinkable pre-insulated nylon splices and terminals, covering ranges from 0.5mm² to 6.0mm².
Approvals
UL Listed