Pico Technology 4444 PicoScope 4000 Series Analogue PC Based Oscilloscope, 4 Analogue Channels, 20MHz - RS Calibrated

20 MHz bandwidth

Flexible 12 and 14-bit resolution

256 MS deep memory

Rejects common-mode noise

Interface for intelligent probes and clamps

Low-voltage probe for millivolts to 50 V

1000 V CAT III probe for high-voltage applications

10000 waveform circular buffer

Up to 100 000 waveforms per second update rate

Serial bus decoding

Mask limit testing

Advanced math and filtering

Measurements with statistics

Advanced digital triggering

USB 3.0 connected and powered

Safe probing of single-phase and three-phase voltages and currents

Measuring power drawn by mobile and IoT devices

Mains quality testing

SMPS design

Hybrid and electric vehicle design

•Motor drives and inverters

Biomedical electronics

Measuring differential signals (CAN, balanced audio) with a single channel

With a differential oscilloscope, measurements are made between two high-impedance inputs, allowing measurements to be made across components and test points where neither side is grounded. Differential inputs also reject common-mode noise: noise picked up equally on both high-impedance inputs is rejected.

Each of the four input channels on the PicoScope 4444 features an intelligent probe interface that detects and identifies compatible probes, and powers them where necessary. Each channel can have its own choice of voltage or current probe.

Non-attenuating probes allow high-resolution, low-noise measurement of signals ranging from millivolts to ±50 V. Attenuating probes allow signals up to 1000 V CAT III to be measured. Current probes are available for currents up to 2000 A.