Kingston 8 GB DDR4 RAM, 3200MHz, SODIMM, 1.2V
- RS-stocknr.:
- 195-8317
- Artikelnummer Distrelec:
- 302-01-875
- Fabrikantnummer:
- KVR32S22S8/8
- Fabrikant:
- Kingston
Subtotaal (1 eenheid)*
€ 100,51
(excl. BTW)
€ 121,62
(incl. BTW)
GRATIS bezorging voor bestellingen van meer dan € 75,00
Tekort aan aanbod
- Plus verzending 1 stuk(s) vanaf 29 december 2025
Onze huidige voorraad is beperkt en onze leveranciers verwachten tekorten.
Aantal stuks | Per stuk |
|---|---|
| 1 + | € 100,51 |
*prijsindicatie
- RS-stocknr.:
- 195-8317
- Artikelnummer Distrelec:
- 302-01-875
- Fabrikantnummer:
- KVR32S22S8/8
- Fabrikant:
- Kingston
Specificaties
Datasheets
Wetgeving en compliance
Productomschrijving
Zoek vergelijkbare producten door een of meer kenmerken te selecteren.
Alles selecteren | Attribuut | Waarde |
|---|---|---|
| Merk | Kingston | |
| Capacity | 8 GB | |
| Speed | 3200MHz | |
| Memory Class | DDR4 | |
| Memory Socket | SODIMM | |
| Pins | 260 | |
| Voltage | 1.2V | |
| CAS Latency | 22 | |
| Alles selecteren | ||
|---|---|---|
Merk Kingston | ||
Capacity 8 GB | ||
Speed 3200MHz | ||
Memory Class DDR4 | ||
Memory Socket SODIMM | ||
Pins 260 | ||
Voltage 1.2V | ||
CAS Latency 22 | ||
The Kingston Value RAM KVR32S22S8/8 is a 1G x 64-bit (8GB) DDR4-3200 CL22 SDRAM (Synchronous DRAM), 1Rx8, non-ECC, memory module, based on eight 1G x 8-bit FBGA components. The SPD is programmed to latency DDR4-3200 timing of 22-22-22 at 1.2V. This 260-pin DIMM uses gold contact fingers.
Power Supply: VDD = 1.2V Typical
VDDQ = 1.2V Typical
VPP = 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Single-rank
On-board I2 serial presence-detect (SPD) EEPROM
16 internal banks, 4 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
PCB: Height 1.18” (30.00mm)
Halogen-Free
VDDQ = 1.2V Typical
VPP = 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Single-rank
On-board I2 serial presence-detect (SPD) EEPROM
16 internal banks, 4 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
PCB: Height 1.18” (30.00mm)
Halogen-Free