Eurotherm EPack DIN Rail Controller Voltage 500V ac/dc Open-Loop Control with Feedforward+Trim, Threshold Limit Control

Afbeelding representeert productcategorie

Subtotaal (1 eenheid)*

€ 1.014,42

(excl. BTW)

€ 1.227,45

(incl. BTW)

Add to Basket
selecteer of typ hoeveelheid
Tijdelijk niet op voorraad
  • Verzending vanaf 13 april 2026
Heeft u meer nodig? Klik op 'Controleer leverdata' voor extra voorraad en levertijden.
Aantal stuks
Per stuk
1 +€ 1.014,42

*prijsindicatie

RS-stocknr.:
790-3612
Fabrikantnummer:
EPACK-1PH/63A/24V/XXX/V2
Fabrikant:
Eurotherm
Zoek vergelijkbare producten door een of meer kenmerken te selecteren.
Alles selecteren

Merk

Eurotherm

Output Type

Voltage

Product Type

Controller

Maximum Current

63A

Minimum Operating Temperature

0°C

Maximum Operating Temperature

45°C

Terminal Type

Plug

Control Type

Open-Loop Control with Feedforward+Trim, Threshold Limit Control (Pa Reduction), I² Control, V² Control, True Power Control, Proportional Limit Control (by transfer V²↔I² or P↔I²)

Maximum Supply Voltage

500V ac/dc

Firing Mode

Intelligent Half Cycle, Fixed Burst Firing, Phase Angle, Variable Burst Firing

Diagnostics

Comms Network Fault, Open Thyristor Detection, Partial Load Failure, Over Current, Under/Over Voltage, Chop Off, Short Circuit Thyristor Detection

Digital Comms

Ethernet Dual Port/Modbus TCP

Auxiliary Power Supply

100 to 500 V

Energy measurement

Yes

Display Type

1.5 in TFT Colour

Maximum Voltage

500V

IP Rating

IP10, IP20

Standards/Approvals

CE, GOST-R, UL, CCC, IEC 60947-4-3, cUL

Width

121 mm

Length

48mm

Input Type

4 to 20 mA, Digital Input, 0 to 10 V, 2 to 10 V, 0 to 20 mA, One Configurable Analogue Input 0 to 5 V, Contact

Mount Type

DIN Rail

Series

EPack

Panel Depth

136.2mm

Niet conform

Land van herkomst:
PL

EPack - Compact SCR Power Controller


EPack power controller is a compact fully featured power controller, combining a high level of functionality and configurability with simplicity of setup and operation. The combination of advanced configurable firing modes allows close matching to load characteristics for maximum process efficiency. EPack is highly configurable and may be adapted for current and future needs using a software key to purchase additional functionality when needed.

Nominal load current from 32A (Stock-no.: 790-3619 & 800-6716) and 63A (Stock-no.: 790-3612 & 800-6725)

24V & 500V versions available

Analogue input signal (voltage and current)

High definition 1.5" TFT display

Configurable via iTools (PC software) or front panel

V2, I2 or true power control

Energy usage measurement

Advanced load diagnostics

Integrated dual port Ethernet switch for “daisy chained” communications

Plug and play Ethernet communications with Zero configuration networking

Modbus® TCP protocol

Compact DIN Rail and bulkhead Mounting Format

Gerelateerde Links