Fluke I310S Current Clamp, 450A DC Max, AC/DC Adapter, 300A ac AC Max - RS Calibrated

The i310s Current Clamp has been designed for use with oscilloscopes and digital multimeters for accurate nonintrusive measurement of AC, DC and complex waveform currents.

Using Hall Effect technology, the clamp can accurately measure currents up to 450 A peak over the frequency range of dc to 20 kHz
These features make it a powerful tool for use in inverters, switch mode power supplies, industrial controllers, automotive diagnostics, and other applications requiring current measurements and/or waveform analysis
Output cable and connections: Safety BNC connector supplied with safety 4 mm adapter
Power Supply: 9 V Alkaline, NEDA 1604/PP3 IEC 6LR61
Safety Standards: EN 61010-1: 2001, EN 61010-2-032: 2002, EN 61010-031: 2002
300 V rms Category III, Pollution Degree 2

Output cable and connections :safety BNC connector supplied with safety 4mm adapter
Power supply is a 9V alkaline
Low battery indicator
Zero adjustment
Output sensitivity: 10mV/A (40A) to mV/A (400A)
Resolution: ±50mA (40A) to ±100mA (400A)
Load impedance is greater10kohms and 100pF
Frequency range (small signal): DC to 20kHz (-3dB)
Phase shift below 1kHz, less than 2 degrees
Temperature coefficient: ±0.1% of reading /°C

Inverters
Switch mode power supplies
Industrial controllers
Automotive diagnostics
Other applications requiring current measurements
Waveform analysis

EN 61010-1: 2001
EN 61010-2-032: 2002
EN 61010-031: 2002
300Vrms CAT III safety rated
EN 61236 :1998 +A1, A2, and A3
IEC 61326-1
CE certified
cCSAus certified